在Xpenology (VM) 安装DSM6.2.1-23824遇到的问题及其解决方案

不好意思。英文写的。不过看图片就行了。安装环境：Esxi 6.5; Bootloader 1.03b.

After the DSM was updated to 23824, My Xpenology VM stopped working. Fortunately, I was able to restore it after hours and hours hardworking. Here is a list of all the major issues and their solutions. Hope it can help you.

Issues:

1. The DSM could not be detected. Bootloader started normally, but NO Network Connection at all.
   • Solution: Change the NIC card from E1000 to E1000e
   • 
2. DSM was detected. But "No disk is found " error was displayed after the web portal was loaded.
   • Solution: Change the Virtual Device Node of the DATA Disk from iSCSI controller to SATA controller
   • 
     
3. DSM was detected. Disks were found. But installation of the DSM failed because "partition cannot be formatted"

• • Solution: Move the DATA disks to the first SATA slot, SATA(0,0). Put the Bootloader disk to the last.
  • 
    

Another issue you may experience is that the VM cannot boot to the Bootloader after the SATA slots switched. To solve the issue, you need go to BIOS and change the boot sequence.

Finally,

​

 

非常感谢楼主给予的指点，按照你的指点在升级后无法进入DSM后按照你的教程设置还是无法进入，获取不到IP
使用环境6.7.求指点，

 

BootLoader 版本？我的是1.03b。

 

1.可以检查下虚拟机的引导是不是EFI模式。
3.引导盘sata0:0，数据盘要在引导盘后面。
2.还有50M的引导盘要设置成非持久，不然装系统就会被格式化，后面又找不到引导器。